Location:Home > TURBO GARRETTS > Turbo T SERIES 16 > How do i replace my water pump on a 2006 isuzu 280

How do i replace my water pump on a 2006 isuzu 280

Time:2018-06-29 07:19Turbochargers information Click:

Isuzu Pump Replace Water 2006

1 Answer Torques for mains nd big ends bearings on isuzu 280



Hope this helps

Nov 19, 2016 | Isuzu Cars & Trucks

1 Answer The reduced power warning is on, and there is a warning light on with a lock. The is a 2006 i 280 Isuzu pickup. Wha could the cause be?

need to have vehicle scanned for problem most auto stores offer this service for free

Sep 09, 2016 | 2006 Isuzu i-280

1 Answer What is the diesel tank capacity of a isuzu kb 280 diesel turbo double cab

22 gallons

May 26, 2014 | 2006 Isuzu i-280

1 Answer Where is located crankshaft position sensor

Go to the art cars

Jan 25, 2014 | 2006 Isuzu i-280

1 Answer Isuzu 280 td 4x4

check for a cracked or blown head gasket? Or flush the system and FYI, rule of thumb on thermostats is 3 out of 5 off the shelf are bad. so may have a defective thermostat. You can drop the stat in a pan of boiling water and watch it to see if it opens up. if it does, its good.

Or water pump.

If you need further help, I’m available over the phone at https://www.6ya.com/ddfselectcategory

Dec 14, 2013 | Isuzu i-280 Cars & Trucks

1 Answer Need to replace front wheel bearing on my 06 I-280. Is it just a bearing or do I have to replace the whole wheel hub?

Should be hub bearing all new cars have it.remove big nut 32 or 34 mm,deep socket .

Feb 04, 2013 | 2006 Isuzu i-280

2 Answers I have 2006 Isuzu I-280 my problem is the engine light came on got the code PO 300 I put new spark plugs I ease the code the light did not came on for awhile now is on again

P0300 = Random/multiple misfires detected.

Something else besides worn spark plugs is causing the misfires. Check for a clogged fuel filter, low fuel pump pressure, fuel pressure regulator stuck in idle (low) mode, leaky spark plug wires, vacuum leaks, and a leaky EGR valve.

Feb 27, 2011 | 2006 Isuzu i-280

1 Answer I need to know how to remove the door panels of my 2006 Isuzu I-280 pickup to replace the speakers.

Hey I don't mean to condemn your car, but what you have is a GM vehicle not a real Isuzu. The real Isuzu was a lot more easier to work with and much more pleasant to drive in my opinion. Anyway, there are a few screws holding the armrest and the door handle plastic flange that needs to be removed first. Then you can pop off the door panel, which is just snap fitted. You might have to look hard for the screws and even use a flat screwdriver pop off the small plastic pieces hiding the screw heads. Make sure you don't try to pop off the panel before removing the screws as this will irrepairably damage the panel.

Dec 30, 2010 | 2006 Isuzu i-280

1 Answer How do I reset the oil change warning for 2006 Isuzu I-280?

drive for about 50 miles and it should reset the obdII

Feb 22, 2010 | 2006 Isuzu i-280

1 Answer Recall Isuzu i-280

2006 ISUZU I-280 EXTERIOR LIGHTING:BRAKE LIGHTS:SWITCH Recall Date: 04/27/2006 Summary: CERTAIN PICKUP TRUCKS MAY EXPERIENCE THE PERMANENT LOSS OF BRAKE LAMP FUNCTION OR BRAKE LAMPS THAT ARE ILLUMINATED AT ALL TIMES. THE CENTER HIGH-MOUNTED STOP LAMP (CHMSL) IS AFFECTED IN BOTH INSTANCES. ALSO, IF EQUIPPED, THE CRUISE CONTROL WILL BECOME INOPERATIVE. ANY TRAILER BRAKE LAMPS WHICH ARE CONNECTED TO THE VEHICLE'S BRAKE LAMP WIRING WILL MIMIC THE VEHICLE'S BRAKE LAMPS WHEN EITHER CONDITION OCCURS. Consequence: A FOLLOWING DRIVER MAY NOT KNOW WHEN THE BRAKES HAVE BEEN APPLIED, AND A REAR-END CRASH COULD OCCUR WITHOUT PRIOR WARNING. Remedy: DEALERS WILL REPLACE THE BRAKE LAMP SWITCH ASSEMBLY. THE RECALL BEGAN ON DECEMBER 5, 2006. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438; GMC AT 1-866-996-9463 OR ISUZU AT 1-800-255-6727. Potential Units Affected: 404733 Notes: ISUZU I-280 06030

May 18, 2008 | 2006 Isuzu i-280

Copyright infringement? Click Here!